Galvanised Tensioning Straining Line Wire | 3.15mm x 160m | 12 gauge

Product Information

Between turning points, attach a temporary wire, low own, ensuring it is not too tight and does not catch the ground. This will then guide the siting of the intermediate posts. Driving in intermediate posts

Diamond mesh and rolled welded wire mesh fences in warmer climates don’t have top rails, but they still need something to support the wire mesh.Lay out materials, describe any potential problems and indicate the positions of the straining posts (decide upon these now if you have not already done so). Demonstrate tool use Ensure all team members are wearing appropriate footwear and clothing and issue specified safety equipment. Introduction At each change of direction of the fence, sever the roll by untwisting the spiral next to the stretching bar, do this before you insert the stretcher bar.

It’s usually the thinnest wire on the fence, at 1.6mm in diameter, and it’s used every foot or about 30 centimeters along each straining wire to secure the mesh. Like binding wire, tie wire is passed around the mesh and straining wire and then twisted together securely. Twisting and Finishing Wires Concrete and Timber Posts - ensure that the straining wires are evenly spaced between top and bottom edge of the fencing (about 100cm down from the top of the fencing up 100cm up from the bottom). Loosely fit the end eyebolts and stretcher bar cleats with nuts (with large washers on both sides of the post), use two cleats and eyebolts with ring-nuts on intermediate straining posts.Use a stretcher bar to ensure equal tension in all lines, or use two wire strainers in tandem: strain up and fix the top and bottom wires, then work inwards. Where the wire is along the side of the posts, either hammer the staples fully home on timber posts, or on cement posts, go along and using short pieces of straining wire, secure the wire at each post as shown right. If roll of chain link fencing runs out before the end of a run, join the rolls by removing a spiral from the end of the roll to be joined on to. This is easily achieved by releasing the ends of the first spiral and winding the spiral along until it is fully removed. Bring together the end of one roll with the beginning of the other roll and reinsert the removed spiral but this time 'knitting' the two rolls together - when fully inserted, close the ends of the spiral which was removed. Splitting a roll of fencing Walk the line of the fence explaining what work will be undertaken. Identify potential hazards and explain how to work safely around them.

We supply a large range of wire coils, all galvanised to prevent the steel from rusting. Line wire can also be used to form fencing without any mesh and also can be used for plant support in gardens and allotments. If you’re building a warm-weather diamond mesh or rolled welded mesh fence, chances are you’re going to need a few different types of wire to construct the fence structure. Nail the rails with galvanized nails driven in at an angle, ensuring the nails are not directly above one another and are set a few centimetres apart. When using a drivall be particularly careful that the post is upright and the people using it wear safety helmets. Straining and staplingBare in mind that if you are using the wire for an art project or precision appliance that all of the different wires have a tolerance of ±0.2mm in their diameter We are offering high quality mild steel 4mm Diameter Straining Wire in various lengths. Key Features of our product: The next kind of wire that is used on warm weather diamond mesh or chain link fences and rolled welded wire mesh fences is binding wire. The most efficient way to work is to form a production line, each team doing a specific job. Pairs can be swapped around at tea or lunch breaks.